Preparation For Installation
The vehicle surface and the brown, magnetic side of the sign should be
cleaned and dried prior to applying.
Make contact on one edge of the sign to the vehicle surface in desired
location. Then, let the adjacent part of the sign contact the vehicle
surface until entire sign is held magnetically to the vehicle. If sign is
not in desired position, remove and repeat process. (DO NOT try to
straighten sign by pulling when it is held magnetically to the vehicle. This
might scratch your vehicle. )
Avoid placing your sign over chrome trim or surface protrusions of any kind.
The temperature of the sign should be at least 60ºF during installation. The
temperature of the vehicle does not matter.
Magnetic vehicle signs will not adhere to areas on your car where plastic
body fillers have been used. In order to avoid losing your signs, use
caution in applying vehicle signs to areas of your car that have been
Your signs should be periodically removed - once a week minimum. Wipe dry
both the vehicle and the back of the sign. Trapped moisture, dirt or
chemicals may harm your vehicle finish. Clean your sign with plain water or
warm water and a mild detergent.
To avoid cracking or breaking, do not fold or crease. Store your magnetic